Bartending

SHAKING, STIRRING, AND STRAINING
Drinks requiring only shaking are covered with a plastic shaker cup and mixed within the glass; whereas shaken and strained or stirred and strained drinks are originally mixed within (a) shaker cups (glass & stainless steel) and then transferred to a glass. Remember to always fill your shaker full of ice before mixing drinks requiring either stirring/shaking and straining. The same applies to glassware; always start with a full glass of ice.

*SAFETY PRECAUTIONS*

Please keep in mind that while directions such as "shoot drink", "drink without using hands", "ignite drink", or "while leaning head over bar pour drink into mouth" are all authentic recipe components, they are only suggestions and should not be attempted if you feel that they might pose a hazard to your health. Make certain to never carry or transport a lit drink, as alcohol is a flammable liquid and should be respectfully treated as such. Before drinking, completely extinguish any drink suggesting ignition.

Always overstock on ice, fresh resupply is critical in the maintenance of professional standards. Whenever glassware or bottles are broken in the vicinity of the ice bin, melt the ice with hot water, clean the bin, and restock with new ice.

Ice

Ice can be one of the most important factors in determining a drink's quality. Generally speaking, the small square-shaped "slices" usually referred to as "bar" ice are best. Aside from preventing premature blender destruction, the smaller style ice cube, will by virtue of increased surface area, make for a significantly colder drink. The resulting reduction in vapor pressure (fumes) from the alcohol makes for a more palatable mixed drink.

As mentioned before in the section on Ice, whenever glassware or bottles are broken in the vicinity of the ice bin, melt the ice with hot water, clean the bin and restock with new ice.

A 2-speed commercial blender is practically a must for quality frozens. Don't destroy a 15-speed kitchen blender trying to crush ice; it's simply not made for the job. Waring® produces a good line of commercial 2-speed Blendor® models that start at less than $90.00.

Liquor Measurement

The use of a shot system has been adopted, whereby a shot is equal to whichever size jigger you use, keeping in mind that the recipes are based on a 1 1/2 oz. shot. When using a different size jigger, correct proportioning can be main­tained by using larger glassware and more mixer if the "shot" is bigger or vice versa if smaller. Use a 1 1/4 oz. shot and the specified sizes and measurements for a milder recipe variation. Splashes are 1 oz., scoops are 4 ozs. and dashes are from 3 to 5 drops. This system was chosen not only because it's quick and easy to use but most importantly, because it's adaptable to your bartending style.

Liquor Measuring Key
Dash-------3 to 5 drops

Scoop------4 ounces

Shot-------1 1/2 ounces

Splash-----1 ounce

Tablespoon-'/2 ounce (3 tspn.)

Teaspoon---'/6 ounce

A.K.A.-----"Also Known As"

S.A.-------"See Also"

V/O--------"Variation or Option"

/----------"or"

R----------"Registered Trademark"

Attention E-zine Editors: You may use this article on your Website or in your e-zine royalty free, as long as you publish the complete article along with everything in the resource box. You must also post this message. Thank you.

Check out more of the same content as well as the best bar equipment click on the links below

Barstool - We have information on the best bar stool for each and every bar style.

Marios barstore - Find every type of bar equipment available on the market for every bar, restaurant, night club or theme bar

Article Source: http://www.wellnessarticlelibrary.com

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated